LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2513 (Interior Trim And Ornamentation -- F250-F550 Super Duty) >> Removal And Installation >> Headliner - Crew Cab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped, remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. If equipped, remove the rear DVD system. For additional information, refer to INFORMATION AND ENTERTAINMENT SYSTEMS .
  3. Remove the RH and LH sun visor screws and the sun visors.
    • If equipped, disconnect the electrical connectors.
      Fig 1: Locating Sun Visor Screw
      G06779606Courtesy of FORD MOTOR CO.
  4. Remove the RH and LH sun visor retaining clips.
    • Remove the sun visor retaining screws.
      Fig 2: Locating Sun Visor Retaining Clips
      G06779607Courtesy of FORD MOTOR CO.
  5. Remove the RH and LH A-pillar trim panels. For additional information, refer to A-PILLAR TRIM PANEL .
  6. Remove the RH and LH B-pillar trim panels. For additional information, refer to B-PILLAR TRIM PANEL - CREW CAB .
  7. Remove the RH and LH rear garment hooks.
    • Open the rear garment hook screw access covers.
    • Remove the 2 rear garment hook screws.
  8. Lower the glove compartment.
    1. Open the glove compartment.
    2. Depress the glove compartment stop and lower the glove compartment.
      Fig 3: Identifying Glove Compartment And Glove Compartment Stop
      G06779633Courtesy of FORD MOTOR CO.
  9. Through the glove compartment opening, disconnect the headliner electrical connector that is located at the RH instrument panel, toward the front of the vehicle.
  10. Remove the RH and LH rear assist handles.
    1. Remove the 4 covers (2 on each handle).
    2. Remove the 4 bolts (2 on each handle).
      • To install, tighten to 12 Nm (106 lb-in).
    3. Remove the 2 B-pillar assist handles.
      Fig 4: Identifying B-Pillar Assist Handle, Cover And Bolt
      G06779581Courtesy of FORD MOTOR CO.
  11. Remove the RH and LH C-pillar trim panels. For additional information, refer to C-PILLAR TRIM PANEL - CREW CAB .
  12. If equipped, remove the roof opening panel trim.
  13. Remove the 3 headliner pushpin retainers.
  14. Remove the rear window. For additional information, refer to GLASS, FRAMES AND MECHANISMS .
    15. NOTE: Make sure not to crease the headliner when removing it from the vehicle.
  15. Remove the headliner.
    • With an assistant, remove the headliner through the rear window glass opening.
  16. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals