Removal and Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Right side shown in illustration, left side similar.

Remove the assist handle bolt covers.

Fig 1: Locating Assist Handle Bolt Covers
Courtesy of FORD MOTOR CO.
Remove the assist handle bolts.
- To install, tighten to 12 Nm (106 lb-in).
  
  Fig 2: Locating Assist Handle Bolts
  Courtesy of FORD MOTOR CO.

NOTE: Carefully rotate the A-pillar trim panel during this step.

Remove the A-pillar trim panel.

NOTE: To avoid damage to the A-pillar trim panel, remove any retaining clips from the body and attach them to the A-pillar trim panel before installing.

To install, reverse the removal procedure.