LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2501 (Transfer Case - Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> Hublock Vacuum Reservoir >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Pulse Vacuum Hublock (PVH) solenoid. For additional information, refer to PULSE VACUUM HUBLOCK (PVH) SOLENOID .
  2. Lift the reservoir upward and separate the reservoir from the shroud.
  3. Remove the hublock vacuum reservoir.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals