LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2500 (Information Center - Instrumentation, Message Center And Warning Chimes -- F250-F550 Super Duty) >> Removal And Installation >> Instrument Cluster (IC) >> Installation

Instrument Cluster (IC): Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the IC  in the instrument panel, connect the electrical connector and install the 2 screws.
  2. If equipped, connect the electrical connectors, position the IC  finish panel and install the 4 screws.
  3. Install the lower instrument panel steering column cover.
  4. If equipped with an automatic transmission, place the selector level in PARK (P).
  5. Install the upper instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  6. If installing a new IC  , download the IC  configuration information from the scan tool into the new IC  . For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
  7. NOTE: If a new IC  is installed, the IC  and the PCM require a parameter reset to allow the IC  and the PCM to recognize each other. Failure to carry out the parameter reset to the IC  and the PCM may result in a no start condition.
NOTE: If equipped, the vehicle's Passive Anti-Theft System (PATS) keys must be programmed to the new IC  .

If installing a new IC  , carry out the parameter reset and key programming procedure.

scientia non olet · About LEMON Manuals