LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2471 (Engine Mechanical - 6.4L 99R Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If reusing the original oil pump drive rotors, install the oil pump drive rotors with the marks pointing outward. Replacement oil pump drive rotors will have no marks and orientation is not necessary.
  1. Lubricate the inner drive rotor with clean engine oil and install onto the crankshaft. Lubricate the outer drive rotor with clean engine oil and mesh with the inner drive gear rotor.
    2. NOTE: Install a new press-in-place gasket.
  2. Install the oil pump housing and the bolts.
    • Tighten the 7 long bolts to 31 Nm (23 lb-ft).
    • Tighten the 4 short bolts to 22 Nm (16 lb-ft).
  3. Install the crankshaft front seal. For additional information, refer to CRANKSHAFT FRONT SEAL .
scientia non olet · About LEMON Manuals