Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: To prevent engine damage, always install 4 new bolts when installing the vibration damper.

NOTE: Apply a light coat of engine oil to the bolts prior to installing the bolts.

NOTE: Use the Strap Wrench to prevent the engine from turning during the tightening of the bolts.

Position the crankshaft pulley and install 4 new bolts in 2 stages, in the sequence shown in the illustration.
- Stage 1: Tighten to 68 Nm (50 lb-ft).
- Stage 2: Tighten an additional 90 degrees.
  
  Fig 1: Identifying Crankshaft Pulley Bolts Sequence
  Courtesy of FORD MOTOR CO.
Vehicles with A/C
Install the A/C drive belt.

Fig 2: Locating A/C Drive Belt
Courtesy of FORD MOTOR CO.

All vehicles
Install the accessory drive belt.

Fig 3: Locating Accessory Drive Belt
Courtesy of FORD MOTOR CO.
Install the cooling fan stator. For additional information, refer to ENGINE COOLING .
Connect the battery LH and RH ground cable(s). For additional information, refer to BATTERY, MOUNTING AND CABLES .