Section 216 (Automatic Transmission - Overhaul - 4R100 - Excursion & F250-F550 Super Duty): Specifications

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, and 2003 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

General Specifications

Item

Specification

Fluid ⁽¹⁾

MERCON® Multi-Purpose (ATF) Transmission Fluid X-2-QDX

MERCON®

Fluid Capacities ⁽²⁾

20 plate oil-to-air cooler

16.1L (17.1 quarts)

26 plate oil-to-air cooler

16.7L (17.7 quarts)

Fluid Filter

Inline Transmission Fluid Filter Kit XC3Z-7B155-AA

Inline Transmission Fluid Filter XC3Z-7B155-BA

Lubricants

Silicone Brake Caliper Grease and Dielectric Compound XG-3

ESE-M1C171-A

Multi-Purpose Grease XG4

ESR-M1C159-A

CAUTION:

⁽¹⁾	Using a transmission fluid that indicates a dual usage (MERCON® and MERCON®V) in a transmission application requiring only MERCON®, may cause transmission damage. Use of any fluid other than the recommended fluid may cause transmission damage.

NOTE: Refer to the fluid level indicator and the Owner's Guide for the type of transmission fluid required. Some fluid labels may indicate dual usage such as MERCON® and MERCON®V. These dual-usage fluids are not to be used in transmissions that use only the MERCON® type fluid. These dual-usage fluids may be used in transmissions that require MERCON®V use.

⁽²⁾

The above fluid capacities are approximate dry fill capacity and include fluid coolers and fluid cooler tubes. Fluid level indicator should be used to determine actual fluid requirement and fluid specifications. Check level at operating temperature. DO NOT OVERFILL. The transmission fluid should be changed every 30,000 miles (48,000 km) regardless of normal or special operating conditions. 5.4L applications with in-tank coolers and OTA may require an additional few ounces.

Fig 1: Band and Clutch Application Chart A