LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Automatic Transmission - Overhaul - 4R100 - Excursion & F250-F550 Super Duty) >> In-Vehicle Repair >> Transmission Insulator & Retainer >> Removal

Transmission Insulator & Retainer: Removal

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, and 2003 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: 4x2 shown, 4x4 similar.
  1. With the vehicle in NEUTRAL position it on a hoist. Refer to Jacking & Lifting .
  2. Remove the nuts.
    Fig 1: Removing Transmission Insulator And Retainer
    G02775032Courtesy of FORD MOTOR CO.
  3. Install a suitable high-lift transmission jack.
    4. CAUTION: Be sure not to raise the back of the transmission too high. If it makes contact with the underbody, damage to the TSS and OSS sensors will occur.
  4. Remove the rear transmission mount.
    1. Raise the transmission up off the rear crossmember support.
    2. Remove the bolts.
    3. Remove the rear transmission mount.
      Fig 2: Removing Rear Transmission Mount
      G02775033Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals