Torque Converter One-Way Clutch Check

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, and 2003 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Special Tools

Courtesy of FORD MOTOR CO.

Insert the One-Way Clutch Holding Tool (307-067) in one of the grooves in the stator thrust washer.

Fig 2: Inserting One-Way Clutch Holding Tool In Stator Thrust Washer Grooves
Courtesy of FORD MOTOR CO.
Install the One-Way Clutch Holding Tool (307-062) in the converter pump drive.

Fig 3: Install One-Way Clutch Holding Tool In Converter Pump Drive
Courtesy of FORD MOTOR CO.
Using torque wrench, turn the special tool counterclockwise while holding the special tool stationary.
- The converter one-way clutch should lock up and hold the specified torque.
- The torque converter one-way clutch should rotate freely in the clockwise direction.
- Try the clutch for lockup and hold in at least five positions.
- If the clutch fails to lock up and hold the specified torque, install a new or remanufactured torque converter.
Fig 4: Checking Converter One-Way Clutch Operation
Courtesy of FORD MOTOR CO.