LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Automatic Transmission - Overhaul - 4R100 - Excursion & F250-F550 Super Duty) >> Disassembly & Assembly Of Subassemblies >> Front Case Bushings >> Assembly

Front Case Bushings: Assembly

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, and 2003 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The front case bushing has three lube grooves. The rear case bushing has one lube groove.
    Fig 1: Installing Front Case Bushing Onto Transmission Extension Housing Bushing Installer
    G01557209Courtesy of FORD MOTOR CO.
  1. Install the front case bushing onto the Transmission Extension Housing Bushing Installer (307-258) and Drawbar (204-029).
  2. Place the Transmission Extension Housing Bushing Installer (307-258) and Drawbar (204-029) with the front case bushing through the case and into the rear case bushing.
    Fig 2: Installing Front Case Bushing
    G01557210Courtesy of FORD MOTOR CO.
    3. CAUTION: Make sure the bushing and tool are centered in the bore.
    Fig 3: Installing Washer & Nut
    G01557211Courtesy of FORD MOTOR CO.
  3. Install the transmission extension housing bushing installer and drawbar then, install the washer and the nut hand-tight.
  4. Hold the bushing installer while turning the nut until the front case bushing is fully seated. Remove the tools.
    Fig 4: Seating Front Case Bushing
    G01557212Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals