LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Cutaway 7.3 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 2118 (Turbocharger Cooling System -- F250-F550 Super Duty) >> Removal And Installation >> Turbocharger Actuator Cooler >> Installation

Turbocharger Actuator Cooler: Installation

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the turbocharger actuator cooler and install the bolts. Tighten the bolts in the sequence shown in 2 stages.
    • Stage 1: Finger-tighten the bolts.
    • Stage 2: Tighten to 7 Nm (62 lb-in).
    2. Fig 1: Tightening Turbocharger Actuator Cooler Bolts In Sequence
    GF0048889Courtesy of FORD MOTOR CO.
  2. Tighten the turbocharger actuator bolts.
    • Tighten to 19 Nm (168 lb-in).
  3. Connect the expansion tank-to-turbocharger actuator cooler hose to the actuator.
  4. Connect the turbocharger actuator cooler-to-radiator hose to the cooler.
  5. Fill and bleed the fuel and turbocharger cooling system. For additional information, refer to Fuel and Turbocharger Cooling System Draining, Filling and Bleeding .
scientia non olet · About LEMON Manuals