Recommended Procedure

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Connect the scan tool. Turn off all accessories. If the vehicle is equipped with a power take-off (PTO) system or auxiliary idle control, it must be turned off to carry out the self-tests.

Carry out the necessary vehicle preparation and a visual inspection. Refer toQUICK TEST OPERATION .
Refer to the scan tool operating article for instructions.
Key ON, engine OFF.
Follow the operating instructions from the menu.
Record the continuous DTCs and freeze frame information from the PCM and the transmission control module (TCM) and refer to the appropriate pinpoint test for continuous DTC diagnostics.
Clear the continuous DTCs after a repair is made.