P2545 - Torque Management Request Input Signal A Range / Performance
WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
P2545 - TORQUE MANAGEMENT REQUEST INPUT SIGNAL A RANGE / PERFORMANCE
| Description: | This DTC is set if there is a torque/engine speed request from the transmission control module (TCM), but at the same time, the powertrain control module (PCM) detects that this request should not be received. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | This DTC can be caused by a network communications issue. Network DTC concerns occur during module-to-module communication. For additional description and operation of the vehicle communication network, refer to MODULE COMMUNICATIONS NETWORK -- F-250-550 (SUPER DUTY PICKUPS) . | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST AE . | |||