P0602 - Powertrain Control Module (Pcm) Programming Error
WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
P0602 - POWERTRAIN CONTROL MODULE (PCM) PROGRAMMING ERROR
| Description: | This DTC indicates a programming error within the vehicle ID (VID) block. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | Using the scan tool, reprogram the VID block. If the PCM does not allow reprogramming of the VID block, reflashing of the PCM is required. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | The VID block must be programmed. Refer toFLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) . | |||