Clutch Rotor/Bearing: Notes
NOTE:
Tools Required:
- External Snap Ring Pliers (J-6083)
- Puller Pilot (J-33023-A)
- Compressor Pulley Puller (J-41552)
- Driver Handle (J-29886)
- Bearing Remover (J-9398-A)
- External Snap Ring Pliers (J-6083)
- Puller Pilot (J-33023-A)
- Compressor Pulley Puller (J-41552)
- Driver Handle (J-29886)
- Support Block (J-21352-A)
- Bearing Installer (J-9481-A)
- Pulley Bearing Staking Tool (J-33019)
- Pulley And Bearing Assembly Installer (J-33017)
- Puller Bar (J-8433-1)
- Forcing Screw (J-8433-3)
- Compressor Holding Fixture (J-34992) - Except V7 Compressor
- Compressor Holding Fixture (J-41790) - With V7 Compressor