Disassembly And Assembly Of Subassemblies: Piston: Assembly

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Connecting rod must be installed into piston with identification markings toward front.

Fig 1: Locating Identification Mark

Courtesy of FORD MOTOR CO.

Position the connecting rod in the piston.
Lubricate the piston pin and pin bore with clean engine oil.

Fig 2: Identifying Piston Pin And Pin Bore
Courtesy of FORD MOTOR CO.
Install the piston pin piston and connecting rod assembly.

Fig 3: Installing Piston Pin Into Piston And Connecting Rod Assembly
Courtesy of FORD MOTOR CO.
Install the piston pin retaining clips in the piston.

Fig 4: Identifying Piston Pin Retaining Clips
Courtesy of FORD MOTOR CO.