Inspection & Verification
- Verify the customer concern by operating the turn signal, cornering and hazard lamps.
- Visually inspect for obvious signs of mechanical and electrical damage.VISUAL INSPECTION CHART
Mechanical Electrical - FEM
- REM
- Instrument Cluster
- Headlamp Switch
- Front Battery Junction Box (BJB) Fuse 3 (10A)
- Rear BJB Fuses:
- 35 (5A)
- 39 (5A)
- 40 (5A)
- Central Junction Box (CJB) Fuses:
- 8 (5A)
- 10 (5A)
- Circuitry
- Bulbs
- If the concern remains after the inspection, connect the diagnostic tool to the Data Link Connector (DLC) located beneath the instrument panel and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
- check that the program card is correctly installed.
- check the connections to the vehicle.
- check the ignition switch position.
- If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool manual .
- Carry out the DATA LINK DIAGNOSTICS TEST. If the diagnostic tool responds with:
- CKT914, CKT915 or CKT70 =ALL ECUS NO RESP/NOT EQUIP, refer to MODULE COMMUNICATIONS NETWORK .
- NO RESP/NOT EQUIP for FEM, refer to MULTIFUNCTION ELECTRONIC MODULES .
- NO RESP/NOT EQUIP for REM, refer to MULTIFUNCTION ELECTRONIC MODULES .
- NO RESP/NOT EQUIP for instrument cluster, refer to INSTRUMENT CLUSTER .
- SYSTEM PASSED, retrieve and record the continuous Diagnostic Trouble Codes (DTCs), erase the continuous DTCs and carry out self-test diagnostics for the REM.
- If the DTCs retrieved are related to the concern, go to the FEM DIAGNOSTIC TROUBLE CODE (DTC) INDEX , REM DIAGNOSTIC TROUBLE CODE (DTC) INDEX , INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) INDEX or SSP RELAY INDEX to continue diagnostics. Refer to HEADLAMPS .
- If no DTCs related to the concern are retrieved, proceed to Symptom Chart to continue diagnostics.