LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 978 (Body Panel System - Front End Body Panels -- Excursion & F250-F550 Super Duty) >> General Procedures >> Hood Alignment

Hood Alignment

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the hood.
  2. Loosen the hood hinge to hood bolts.
    Fig 1: Loosening Hood Hinge To Hood Bolts
    G03465406Courtesy of FORD MOTOR CO.
  3. Move the hood forward or rearward and from side to side as required for proper hood fit.
    Fig 2: Moving Hood Forward Or Rearward And From Side To Side As Required For Proper Hood Fit
    G03465407Courtesy of FORD MOTOR CO.
  4. Tighten the hood hinge to hood bolts.
    Fig 3: Tightening Hood Hinge To Hood Bolts
    G03465408Courtesy of FORD MOTOR CO.
  5. Adjust the hood height using the hood adjustment bumpers until flush with the fenders.
scientia non olet · About LEMON Manuals