Check Valve - Vacuum Booster Only
WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
The function of the power brake booster check valve is to allow manifold vacuum to enter the power brake booster and prevent the escape of vacuum in case manifold vacuum is lost during sustained full throttle operation.
To test the function of the power brake booster check valve:
- Start and run the engine for at least 10 seconds.
- Operate the brake pedal to check for power assist.
- Disconnect the vacuum booster hose (2A047) from the power brake booster. Do not remove the power brake booster check valve from the power brake booster.
- There should be enough vacuum retained in the power brake booster for at least one more power-assisted brake operation.
- Replace the power brake booster check valve if it fails the above test.