LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 493 (Instrument Panel And Console) >> Removal And Installation >> Instrument Cluster Finish Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2003 Mercury Sable and 2003 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the steering column to the full tilt-down position.
  2. Remove the instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL CENTER FINISH PANEL .
  3. Remove the headlamp switch. For additional information, refer to EXTERIOR LIGHTING .
    4. NOTE: If equipped with a steering column selector lever, position the lever in the 1 position.
    Fig 1: Removing Instrument Cluster Finish Panel
    G01596284Courtesy of FORD MOTOR CO.
  4. Remove the instrument cluster finish panel.
    1. Remove the screws.
    2. Remove the instrument cluster finish panel.
    • Disconnect the electrical connectors.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals