Removal and Installation

WARNING: This page is about a different car, the 2003 Mercury Sable and 2003 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

Disengage the LED module from the parcel shelf.
1. Insert two thin bladed 20 mm (0.8 in) wide tools (approximately 60 mm from the outside edges of the LED module) and push rearward to disengage the retaining clips.
2. Lift the front of the LED module from the parcel shelf.
Fig 1: Disengaging LED Module From Parcel Shelf
Courtesy of FORD MOTOR CO.
Remove the LED module.
- Disconnect the connector and pull the LED module forward.
Fig 2: Removing LED Module
Courtesy of FORD MOTOR CO.
Remove the rear seat backrest and the rear seat cushion. For additional information, refer to SEATING .
Remove the LH and RH roof trim panels.

Fig 3: Removing Roof Trim Panels
Courtesy of FORD MOTOR CO.
Remove the pin-type retainers and the parcel shelf.

Fig 4: Removing Pin-Type Retainers And Parcel Shelf
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.