LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Exterior Lighting System) >> Removal And Installation >> Brake Pedal Position (BPP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2003 Mercury Sable and 2003 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the BPP switch.
    1. Disconnect the electrical connector.
    2. Remove the self-locking pin.
    3. Remove the BPP switch from the brake master cylinder push rod.
    Fig 1: Removing BPP Switch From Brake Master Cylinder Push Rod
    G01595187Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals