Removal and Installation

WARNING: This page is about a different car, the 2003 Mercury Sable and 2003 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the accelerator pedal cable.
1. Position the accelerator pedal to relieve tension on the accelerator cable.
2. Depress the tabs on the accelerator pedal retaining pin and disconnect the cable.
  
  Fig 1: Identifying Accelerator Pedal Cable
  Courtesy of FORD MOTOR CO.
Remove the accelerator pedal.
- Remove the nuts.
- Remove the accelerator pedal assembly.
  
  Fig 2: Removing Nut Of Accelerator Pedal Assembly
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.