Pump Shaft

WARNING: This page is about a different car, the 2003 Mercury Sable and 2003 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Inspect the pump drive shaft in the area that the bearings ride. If worn, install a new shaft and main control.

Fig 1: Identifying Teflon® Seals And Inspect Shaft

Courtesy of FORD MOTOR CO.

Remove the Teflon® seals and inspect the shaft.

NOTE: Make sure that the seals are installed correctly.

Fig 2: Identifying Pump Shaft Seals

Courtesy of FORD MOTOR CO.

Install 4 new seals on the pump shaft.