Safety Belt Shoulder Height Adjuster With Stripped Weld Nuts

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Special Tool(s)

Fig 1: Identifying Special Tool(s)

Courtesy of FORD MOTOR CO.

Remove the B-pillar trim panel. Refer to BODY SYSTEM - GENERAL INFORMATION .
Use the half-inch drill with integral stop provided in D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.

Fig 2: Drilling Out Damaged Threads In Upper Pillar Structure
Courtesy of FORD MOTOR CO.
Apply a suitable lubricant to the M14 x 1.5 tap with integral stop provided in D-Ring Installation Kit and tap new threads.
NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.

Fig 3: Tapping New Threads
Courtesy of FORD MOTOR CO.
Use a threaded insert (N807170-S190) provided in the D-Ring Installation Kit and screw it into the retapped hole until it is slightly below the surface.

Fig 4: Screwing Threaded Insert Into Retapped Hole
Courtesy of FORD MOTOR CO.
Use a hammer to lightly tap the installation tool provided in the D-Ring Installation Kit several times to seat the insert keys.
NOTE: If the two bolts on the height adjuster are not stripped, install the height adjuster. Refer to the appropriate height adjuster procedure.

Fig 5: Installing D-Ring Installation Kit To Seat Insert Keys
Courtesy of FORD MOTOR CO.