Wiper Pivot Arm - Rear: Installation

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Operate the rear window wiper motor to the park position.
1. Turn key to RUN position.
2. Turn the rear window wiper switch to the INT 1 position.
3. Allow the rear window wiper motor to operate for at least one cycle.
4. Turn the rear window wiper switch to the OFF position.
  
  Fig 1: Operating Rear Window Wiper Switch To On And Off Position
  Courtesy of FORD MOTOR CO.
Install the rear wiper pivot arm.
1. Connect the rear window washer hose.
2. Install the rear wiper pivot arm with the wiper blade parallel to the bottom of the rear window.
3. Install the retaining nut.
  
  Fig 2: Installing Rear Wiper Pivot Arm
  Courtesy of FORD MOTOR CO.
Install the rear wiper pivot arm cover.

Fig 3: Installing Rear Wiper Pivot Arm Cover
Courtesy of FORD MOTOR CO.
Operate the rear wiper for at least one cycle and observe that the pivot arm is in the correct park position once the rear wiper motor is allowed to park.
If the rear wiper pivot arm does not park in the correct position, repeat steps one and two.