LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 445 (Handles, Locks, Latches And Entry Systems -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Keyless Entry Keypad >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. Refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the front door trim panel. Refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Position the watershield aside.
  4. Disconnect the keypad electrical connector.
    • Release the harness pin-type retainers.
  5. Remove the keyless entry keypad and harness.
    1. Remove the clip.
    2. Remove the keyless entry keypad and harness.
      Fig 1: Removing Keyless Entry Keypad And Harness
      G01556167Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals