LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 445 (Handles, Locks, Latches And Entry Systems -- Excursion & F250-F550 Super Duty) >> Diagnosis And Testing >> Locks, Latches and Entry Systems - Module Controlled >> Principles of Operation >> Autolock Enable/Disable - Using the Ignition Switch

Autolock Enable/Disable - Using the Ignition Switch

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Another way to turn the autolock feature off/on is by following this series of steps:

  1. Close all doors.
  2. Confirm that the ignition switch is in the OFF position.
  3. Turn the ignition switch from OFF to RUN.
    NOTE: Steps four through eight must be carried out within 30 seconds.
  4. Press UNLOCK three times.
  5. Turn the ignition switch from RUN to OFF.
  6. Press UNLOCK three times.
  7. Turn the ignition switch from OFF to RUN.
  8. Verify that the horn chirps. This indicates the enable/disable mode and now is ready to accept program changes.
  9. Press UNLOCK once to command the vehicle security module to toggle the autolock/relock feature OFF.
  10. Press LOCK once to enter the command.
  11. Verify that the horn chirps one time. There should only be one chirp indicating that the autolock/relock feature has been disabled. If one chirp is heard followed by a longer sound of the horn, the autolock/relock feature has just been enabled. Return to Step  10.
  12. Turn the ignition switch to the OFF position to exit the enable/disable mode.
scientia non olet · About LEMON Manuals