Removal and Installation

WARNING: This page is about a different car, the 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, 2003 Ford Cab & Chassis, and 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the instrument panel cluster finish panel. Refer to INSTRUMENT PANEL - Cluster Finish Panel .
Remove the screws and the utility hook.
- If equipped with the dual fuel switch bezel, disconnect the electrical connector.
  
  Fig 1: Removing Screws And Utility Hook
  Courtesy of FORD MOTOR CO.
Remove the lower ashtray/beverage holder screws.
NOTE: Open the ashtray/beverage holder to gain access to the lower beverage holder screws.

Fig 2: Removing Lower Ashtray/Beverage Holder Screws
Courtesy of FORD MOTOR CO.
Remove the ashtray/beverage holder.
1. Remove the upper screws.
2. Remove the ashtray/beverage holder.
  
  Fig 3: Removing Ashtray/Beverage Holder
  Courtesy of FORD MOTOR CO.
Remove the instrument panel center finish panel.
1. Remove the screws.
2. Remove the instrument panel center finish panel.
- Disconnect the electrical connector.
  
  Fig 4: Disconnecting Electrical Connector
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.