Removal and Installation
WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the seat backrest. Refer to FRONT SEAT BACKREST - Bench .
- Remove side release handle.
- Push clip out of slot and remove handle.
- Roll seat back trim cover to expose seat latch bolts.
- Release lower J-clip and uncover upper seat latch attachment bolts.
- Remove the two bolts and remove the front seat latch.
- To install, reverse the removal procedure.