LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 442 (Seat System -- Excursion & F250-F550 Super Duty) >> Disassembly And Assembly >> Front Seat Cushion - Bench >> Disassembly and Assembly

Disassembly and Assembly

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat back. Refer to FRONT SEAT BACKREST - Bench .
  2. Remove the four nuts and remove the two front seat floor supports.
    Fig 1: Removing Nuts And Remove Two Front Seat Floor Supports
    G01555683Courtesy of FORD MOTOR CO.
  3. Remove the four bolts and remove the front seat tracks.
    Fig 2: Removing Bolts
    G01555684Courtesy of FORD MOTOR CO.
  4. Unfasten the eight seat cushion cover J-clips and remove the seat cushion cover.
    Fig 3: Unfastening Seat Cushion Cover J-Clips
    G01555685Courtesy of FORD MOTOR CO.
  5. Remove the seat cushion foam pad from the seat frame.
  6. To assemble, reverse the disassembly procedure.
    NOTE: Make sure tracks inboard and outboard are synchronize. Check track engagement and rear track spring.
scientia non olet · About LEMON Manuals