LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 428 (Charging System - Battery, Mounting And Cables - Excursion & F250-F550 Super Duty) >> Removal And Installation >> Battery >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery cables. Refer to Battery Disconnect  or BATTERY DISCONNECT - Dual .
  2. Remove the bolt and the battery hold down clamp.
    Fig 1: Removing Bolt And Battery Hold Down Clamp
    G01555188Courtesy of FORD MOTOR CO.
  3. Remove the battery.
    WARNING: When lifting a battery, excessive pressure on the end walls could cause acid to spew through the vent caps, resulting in personal injury. Lift with a battery carrier or with hands on opposite corners. Failure to follow these instructions may result in personal injury.
    Fig 2: Removing Battery
    G01555189Courtesy of FORD MOTOR CO.
  4. If equipped, remove the battery cover.
    CAUTION: Be sure the battery cover is reinstalled to avoid premature battery failure.
  5. To install, reverse the removal procedure.