Switch - Key-In-Ignition Warning: Removal

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the ignition switch lock cylinder.
1. Insert the ignition key and turn to the RUN position.
2. Insert a punch in the access hole of the steering column and press the release tab while pulling out the ignition switch lock cylinder.
  
  Fig 1: Inserting Punch In Access Hole Of Steering Column
  Courtesy of FORD MOTOR CO.
Remove the key-in-ignition warning switch.
1. Pry the clip downward.
2. Release the key-in-ignition warning switch from the rear of the ignition switch lock cylinder.
  
  Fig 2: Releasing Key-In-Ignition Warning Switch From Rear Of Ignition Switch Lock Cylinder
  Courtesy of FORD MOTOR CO.