LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 425 (Information And Message Center System - Excursion & F250-F550 Super Duty) >> General Procedures >> Compass Zone Adjustment >> Compass Calibration Zones

Compass Calibration Zones

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Compass Calibration Zones
G01555123Courtesy of FORD MOTOR CO.
  1. The zone setting is factory set to Zone 8. Check the Compass Calibration Zone map to verify the correct compass zone setting for your geographic location.
  2. Gently press both buttons for three to four seconds until ZONE is displayed.
  3. Release the switches. Zone and the current zone setting will be displayed.
  4. Press either switch to cycle through all possible zone settings. Stop cycling when the correct zone setting for your location is displayed.
  5. Release the switch to exit the zone setting mode. After five seconds of no button activity, the module will store the current zone and leave the mode.
scientia non olet · About LEMON Manuals