Removal And Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Disconnect the rear parking brake cable and conduit. For additional information, refer to REMOVAL & INSTALLATION article.
- Remove the axle shaft. For additional information, refer to REMOVAL AND INSTALLATION article.
- Remove the 4 retainers and the brake caliper anchor plate.
- To install, tighten to 68 Nm (50 lb-ft).
- To install, reverse the removal procedure.
WARNING:
Use tools, not fingers, to hold flagnuts. Flagnuts may slip or spin unexpectedly when removing fasteners. Failure to follow this instruction may result in injured fingers.