Removal And Installation

LH or RH Fenders 

1. Remove the headlamp assembly. For additional information, refer to EXTERIOR LIGHTING article.
2. Remove the fender splash shield. For additional information, refer to Fender Splash Shield .
3. If equipped, remove the fender moulding. For additional information, refer to EXTERIOR TRIM AND ORNAMENTATION article.
4. If equipped, remove the rocker panel moulding. For additional information, refer to EXTERIOR TRIM AND ORNAMENTATION article.

RH Fender 

5. Remove the antenna mast and the antenna base fender grommet.
Fig 1: Antenna Mast & Antenna Base Fender Grommet
Courtesy of FORD MOTOR CO.

LH or RH Fenders 

6. If equipped, remove the side turn indicator.
   1. Push the side turn indicator rearward.
   2. Pull outward from the front and remove the side turn indicator.
      • Disconnect the electrical connector.
Fig 2: Removing Side Turn Indicator
Courtesy of FORD MOTOR CO.
7. Remove the 2 lower fender bolts.
   • To install, tighten to 12 Nm (9 lb-ft).
NOTE: The front door must be open to gain access to the rear fender bolt.
8. Remove the rear fender bolt.
   • To install, tighten to 12 Nm (9 lb-ft).
9. Remove the radiator support brace fender bolt.
   • To install, tighten to 12 Nm (9 lb-ft).
NOTE: On the RH side, the antenna base is mounted to the body inside the fender opening. The RH fender must be lifted over the base during removal.
10. Remove the 4 upper fender bolts and the front fender.
    • To install, tighten to 11 Nm (8 lb-ft).
11. To install, reverse the removal procedure.