Rear Side Crash Sensor: Removal
WARNING: This page is about a different car, the 2003 Mercury Mountaineer and 2003 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM.
- Remove appropriate rear door scuff plate. Remove rear seat belt anchor from rear quarter trim. Pull out on front of rear quarter trim panel, releasing retaining clips, and allowing access to rear side crash sensor. Disconnect rear side crash sensor electrical connector. See Figure . Remove rear side crash sensor mounting bolts and crash sensor.