LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Supplemental Inflatable Restraint System -- Excursion & F250-F550 Super Duty) >> Removal & Installation >> Driver-Side Air Bag Module >> Installation

Driver-Side Air Bag Module: Installation

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air bag simulator from clockspring connector. To install, reverse removal procedure. Tighten driver-side air bag module mounting bolts to specification. See TORQUE SPECIFICATIONS .
  2. Connect negative battery cable. With air bag simulators installed at all remaining deployable devices, perform system operation check. See SYSTEM OPERATION CHECK . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals