LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 2169 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Intake Manifold Runner Control (IMRC) Actuator - 6.8L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
  2. Disconnect the intake manifold runner control (IMRC) actuator electrical connector.
  3. Remove the 3 bolts.
    • To install, tighten to 6 Nm (53 lb-in).
  4. Disconnect the IMRC rod pivot pin from the intake manifold rod and remove the IMRC.
    • Lubricate the IMRC rod pivot pin with clean engine oil prior to installation.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals