LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 2167 (Engine Cooling System - F250-F550) >> Removal And Installation >> Block Heater - Gasoline Engines >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding  in this article.
    2. CAUTION: Do not loosen the block heater retaining screw more than necessary for removal. The nut can fall off inside the engine and damage the cooling system.
  2. Loosen the block heater retaining screw and remove the block heater.
    • To install, tighten to 4 Nm (35 lb-in).
    3. CAUTION: Route the block heater power cable away from hot or rotating components, or damage to the cable can occur.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals