Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
All safety belt assemblies (including retractors, belt tension sensor [BTS] if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of injury in collisions.
- Remove the rear seat backrest and seat cushion. For additional information, refer to SEATING article.
- Remove the 3 lower anchors and tethers for children (LATCH)-to-seat riser bolts and LATCH.
- To install, tighten to 48 Nm (35 lb-ft).
- To install, reverse the removal procedure.