Removal & Installation (3.0L 4V)
WARNING: This page is about a different car, the 2003 Mercury Sable and 2003 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
Noting spark plug wire position, remove spark plug wire by slightly twisting while pulling upward. Disconnect spark plug wires from ignition coil by twisting while pulling upward. Open spark plug wire separators and remove spark plug wires. To install, reverse removal procedure. Ensure spark plug wire position noted during removal procedure. Apply Silicone Dielectric Compound to inside of spark plug wire boots.