Performing Self-Test
WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
To perform self-test, turn ignition off. Ensure test equipment is properly attached. If vehicle is equipped with an auxiliary powertrain control system (RPM control), it must be turned off before performing self-test.
- Perform the necessary vehicle preparation and visual inspection.
- Refer to the scan tool manufacturer manual for scan tool instructions.
- Select RETRIEVE/CLEAR CONTINUOUS MEMORY DTCs.
- Turn key on.
- Follow operating instructions from the menu.
- Select RETRIEVE/CLEAR CONTINUOUS DTCs.
- Turn ignition on.
- Follow operating instructions from the menu.
- Record DTCs and perform appropriate system test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
- After test has been completed, cycle ignition off before performing other self-tests or driving vehicle.
- Continuous Memory DTCs must be cleared after repair.