Accessing Ford Specific PIDs

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch to OFF position. Ensure test equipment is properly attached. Using NGS tester, perform the following steps:

Select VEHICLE & ENGINE SELECTION menu.
Select NEW VEHICLE, YEAR & MODEL.
Select DIAGNOSTIC DATA LINK.
Select PCM - POWERTRAIN CONTROL MODULE.
Select PID/DATA MONITOR & RECORD.
Turn ignition switch to ON position or start engine and allow to idle.
Follow operating instructions from scan tool menu.
Select PIDs and press START to begin monitoring. If PID value is not as specified, perform appropriate SYSTEM TEST.