Removal (Spring Lock Coupling)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Relieve fuel pressure. See RELIEVING FUEL PRESSURE . Remove retaining clip from spring lock coupling. See Figure. DO NOT use screwdriver or sharp object when removing retaining clip, as spring lock coupling may be damaged.
- Twist both fuel lines to release seal adhesion on "O" rings. Spring Lock Coupling Remover (D87L-9280-A for 3/8" fuel line) or (D87L-9280-B for 1/2" fuel line) is used to release spring lock coupling.
- Install spring lock coupling remover on spring lock coupling so spring lock coupling remover enters cage opening on spring lock coupling. See Figure. This allows garter spring in spring lock coupling to be released.
- Push spring lock coupling remover into cage opening to release female fitting on fuel line from garter spring in spring lock coupling. Pull fuel lines apart. Remove spring lock coupling remover.