LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Engine - 7.3L V8 Turbo Diesel) >> Removal & Installation >> Front Cover >> Installation

Front Cover: Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure sealing surfaces on cylinder block and front cover are clean. Install NEW gaskets on front cover and apply silicone sealant to sealing grooves on front cover. See Fig 1.
  2. Install front cover on cylinder block with retaining bolts finger tight. Using NEW gasket, install water pump. Tighten water pump bolts to specification. See TORQUE SPECIFICATIONS .
  3. Tighten front cover retaining bolts to specification. See TORQUE SPECIFICATIONS . To install remaining components, reverse removal procedure. Ensure proper procedure is used when installing vibration damper. See CRANKSHAFT FRONT SEAL .
Fig 1: Applying Sealant On Front Cover
G99H03747Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals