LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Engine - 7.3L V8 Turbo Diesel) >> Removal & Installation >> Camshaft >> Installation

Removal & Installation: Camshaft: Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. If installing camshaft thrust plate and camshaft gear on camshaft, install camshaft thrust plate on camshaft. Ensure key is installed in camshaft and camshaft gear keyway and key are free of burrs.
    CAUTION: DO NOT heat camshaft gear at more than 500°F (260°C) or camshaft gear will be distorted.
  2. Heat camshaft gear to 500°F (260°C). DO NOT exceed specified temperature of camshaft gear will be distorted. Press heated camshaft gear onto camshaft, with timing mark facing away from camshaft. Ensure camshaft gear is seated against shoulder on camshaft.
  3. To install, lubricate camshaft journals with engine oil and camshaft lobes with multipurpose grease. Install camshaft so camshaft timing mark and crankshaft timing mark are aligned. See Figure. Install and tighten camshaft thrust plate bolts to specification. See TORQUE SPECIFICATIONS .
  4. To install remaining components, reverse removal procedure. Ensure proper procedure is used when installing front cover, rocker arm assemblies and push rods.
scientia non olet · About LEMON Manuals