LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Engine - 7.3L V8 Turbo Diesel) >> Engine Oiling >> Oil Cooler Assembly >> Installation

Oil Cooler Assembly: Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using NEW gaskets, install oil cooler assembly onto cylinder block. Install and tighten oil cooler rear header-to-cylinder block bolts until bolts are snug. See Figure. Install and tighten oil cooler front header-to-cylinder block bolts to specification. See Figure. See TORQUE SPECIFICATIONS .
  2. Lower engine. Install driver-side engine mount. Tighten oil cooler rear header-to-cylinder block bolts to specification. See TORQUE SPECIFICATIONS . To install remaining components, reverse removal procedure. Adjust engine oil level. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING  under REMOVAL & INSTALLATION.
  3. If engine oil leaked into cooling system due to defective oil cooler, drain and flush cooling system as necessary. See COOLING SYSTEM BLEEDING  under REMOVAL & INSTALLATION. If coolant leaked into crankcase due to defective oil cooler, change engine oil and oil filter.
scientia non olet · About LEMON Manuals