LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Clutch System - F250-F550 Super Duty) >> Removal & Installation >> Clutch Slave Cylinder >> Installation (F250-F550)

Installation (F250-F550)

WARNING: This page is about a different car, the 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Hold the slave cylinder over a suitable container and angle the slave cylinder so that the hydraulic tube connection port is above the push rod. Fill the slave cylinder with High Performance DOT 3 Motor Vehicle Brake Fluid (C6AZ-19542-AB).
  2. Remove the cap from the opening in the hydraulic tube. Position the NEW "O" ring seal on the end of the hydraulic tube. Coat the "O" ring seal with High Performance DOT 3 Motor Vehicle Brake Fluid (C6AZ-19542-AB).
  3. Connect and secure the slave cylinder to the hydraulic tube. Connect the hydraulic tube to the slave cylinder. Install the NEW roll pin. See Figure . Bleed the clutch hydraulic system. See BLEEDING  .
  4. Install the slave cylinder. Compress and twist the slave cylinder to lock it onto the transmission. Lower the vehicle. Test the system for normal operation.
scientia non olet · About LEMON Manuals