Installation (F250-F550)
WARNING: This page is about a different car, the 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When installed correctly, the flat side of the clutch pedal position switch must face the tab protruding from the clutch master cylinder, and the switch wiring connector must be in the 12 o'clock position. Incorrect installation will damage the clutch pedal position switch and cause insufficient clutch pedal travel.
- Seat the clutch master cylinder rubber seal to the bulkhead after locking the clutch master cylinder in the clutch pedal and support bracket.
- Route the clutch master cylinder-to-slave cylinder hydraulic tube under the brake booster after installing the clutch master cylinder.
- Correctly position the CPP switch when installing it on the clutch master cylinder push rod. See Figure .